Steg K2.04D

A feature of STEG Class D amplifiers line is the very low distortion that are able to maintain even at very low loads. Thanks to LOW TOLERANCE OF PASSIVE COMPONENTS AND THE LAYOUT thoughtful design, that reduce to a minimum the loss of power and make excellent performances. The components used is of the type selected and of particular value, are used in low tolerance resistors and capacitors, coupling in high linearity with low thermal drift and polyester capacity made specifically for audio applications. The choice of each individual device has been studied in every detail, every element finds its best placement in the delicate balance of the electrical system in order to ensure maximum performance, invariable in time.

PROTECTION SYSTEM
The K1 | 5000 integrates two a protection systems a global managed by a microprocessor that has the task to perform, in a continuous manner, the control of the following functions:

• Output short circuit

• Direct current to the loudspeaker leaders

• Increase in temperature

• Muting the switch-on

• Supply voltage out of range

• Intelligent fan control "INTELLISPEED"

The numerous "sensors" on the circuit sending a continuous data stream that is processed at high speed. Thanks to dedicated software, the protection system reacts instantaneously, intervening appropriately and reporting any malfunctions via the LEDs on the control panel. The other protection system is managed by the modulator which controls the switching circuit on the final stage.

POWER:

Power 4 ohm stereoWatt RMS - 11 to 14.4 Volt 500 x 2

Power 2 ohm stereoWatt RMS - 11 to 14.4 Volt 900 x 2

Power 1 ohm stereoWatt RMS - 11 to 14.4 Volt 1700 x 2

Power 4 ohm monoWatt RMS - 11 to 14.4 Volt 2000 x 1

Power 2 ohm monoWatt RMS - 11 to 14.4 Volt 3500 x 1



ENTRY SENSITIVITY:

Volt RMS 0.5 V - 5 V



DIMENSIONS:

640 x 56 x 232 mm



WEIGHT:

8.26 Kg